ATSG FORD 4R100, Manual

Page: 47 / 120

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
47
Figure 60
Continued on Page 48.
Copyright © 2003 ATSG
OVERDRIVE CARRIER
AND CENTER SHAFT
ASSEMBLY
TIGHTEN CENTER
BOLT TO 7 N·m
(65 IN.LB.)
CLUTCH SPRING
COMPRESSOR PLATE
CLUTCH SPRING
COMPRESSOR BAR
CLUTCH SPRING
COMPRESSOR BAR
SNAP RING
CLUTCH SPRING
FIXTURE
NUMBER 5
THRUST BEARING
TRANSMISSION DISASSEMBLY
Internal Components (Cont'd)
Figure 62
Figure 61
10. Remove the overdrive carrier and center shaft
assembly, as shown in Figure 60, and set aside
for the component rebuild section.
11. Remove the number 5 thrust bearing, as shown
in Figure 60, which may be on center support.
12. Install clutch spring compressor as shown in
Figure 61, or equivalent, to compress the
intermediate/overdrive clutch cylinder so that
snap ring can be removed.
13. Remove snap ring with large a screwdriver as
shown in Figure 62, and then remove the
compressor tool.