Atop SE59XX-SDK, User Manual, Page: 28 / 75

SE59XX-SDK
Software development Kit
User Manual
V1.2
Starting network...
[ 6.877040] device eth0 entered promiscuous mode
[ 6.909977] net eth0: initializing cpsw version 1.12 (0)
[ 6.971560] net eth0: phy found : id is : 0x2000a212
[ 6.979199] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 6.985310] 8021q: adding VLAN 0 to HW filter on device eth0
net.ipv6.conf.eth0.accept_ra = 1
[ 7.048551] device eth1 entered promiscuous mode
[ 7.090144] net eth1: initializing cpsw version 1.12 (0)
[ 7.150504] net eth1: phy found : id is : 0x2000a212
[ 7.156080] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
[ 7.162240] 8021q: adding VLAN 0 to HW filter on device eth1
net.ipv6.conf.eth1.accept_ra = 1
Starting atop_ntp.sh: OK
Starting dropbear sshd: OK
Starting ProFTPD: [ 7.332967] warning: `proftpd' uses 32-bit capabilities (legacy support in use)
done
Starting stunnel: [.] stunnel 5.09 on arm-buildroot-linux-gnueabihf platform
[.] Compiled/running with OpenSSL 1.0.2 22 Jan 2015
[.] Threading:FORK Sockets:POLL,IPv6 TLS:ENGINE,FIPS,OCSP,PSK,SNI
[ ] errno: (*__errno_location ())
[.] Reading configuration from file /etc/stunnel/stunnel.conf
[.] UTF-8 byte order mark detected
[ ] Enabling support for engine "capi"
[!] error queue: 2606A074: error:2606A074:engine routines:ENGINE_by_id:no such engine
[!] ENGINE_by_id: 260B606D: error:260B606D:engine routines:DYNAMIC_LOAD:init failed
[!] Line 18: "engine = capi": Failed to open the engine
FAIL
Starting network management services: snmpd.
Welcome to ATOP system
ATOP login: