Atop SE59XX-SDK, User Manual, Page: 15 / 75

SE59XX-SDK
Software development Kit
User Manual
V1.2
2.3 Firmware upgrade
There are two ways to upgrade the firmware on the SE59XX platform:
2.3.1 Use boot-loader update via console port
Prepare a Debug Cable (RJ45 to Serial) and a CAT5E Ethernet cable. Then, follow below figure to connect the
Debug port to PC’s COM and CAT5E cable to connect to the Device’s LAN1 Ethernet port to any Host PC’s
Ethernet port.
Figure 2.2 Console firmware update- connections
On your PC, run Windows’ "Super Terminal" setup COM port parameters as follows:
-
Port: the connected COM port
-
Baud Rate: 115200 bps
-
Parity: none
-
Data: 8 data bits
-
Stop: 1 stop bit
-
Flow control: none