Industrial Managed
Ethernet Switch
User Manual
Configuring
with a Web
Browser
Page
37
of
49
2.7.2
HTTPS feature
The
HTTPS
or HyperText Transfer Protocol Secure feature is another feature under the
Management
function. This
page presents the current setting of
HTTPS
for the managed switch’s web interface as shown in
Figure 2.42. To
enable the
HTTPS
, the user can click on the gear icon to bring up the
HTTPS Setting
pop-up window as shown in
Figure 2.43. Next checking the
Enabled
box to redirect web interface access to HTTPS protocol. After you finished,
clicking on the
Save Changes
button to save any changes or clicking on the
Save Changes and Apply
button to save
and apply the setting.
Figure 2.42 HTTPS Feature
Figure 2.43 HTTPS Setting Pop-up Window
2.7.3
SNMP feature
S
imple
N
etwork
M
anagement
P
rotocol
(
SNMP
) is a protocol for managing devices on IP networks. It exposes
management data in the form of variables on the managed systems which describe the system configuration. These
variables can then be queried or defined by the users. The SNMP is used by network management system or third-
party software to monitor devices such as managed switches in a network to retrieve network status information
and to configure network parameters. The Atop
’
s managed switch support SNMP and can be configured through
this feature under the Management function.
shows the SNMP feature’ s web page. It consists of four sections:
SNMP Mode Setting
,
SNMP v1/v2c
Agent Setting
,
SMPT v1/v2c Trap Setting
and
SNMP v3 Configuration
. The current version of SNMP configured to
run on the switch can be viewed behind the
SNMP Mode Setting
. The
SNMP Agent Version
can be set to either
SNMP v1/v2c
or
SNMP v3
. Note that depending on the
SNMP Agent Version
selection some of the sections will be
