4
This instrument is with disk mounted type.
●
Installed places
The instrument should be installed in the interior, where wind and rain as well as direct solar radiation should
be avoided.
●
Places with good ventilation
To prevent the interior temperature of the instrument from increasing, please install the instrument at the
places with good ventilation.
●
Places with less mechanical vibration
Please choose places with less mechanical vibration to install the instrument.
●
Horizontal places
Please do not tend to the left or the right when installing this instrument, but should try best to keep
horizontal (able to tend to the back with the maximum of 30°).
-----------------------------------------------------------------------------------------------------------------------------------------
! Note
* When moving the instrument from the place with low temperature and humidity to the place with high
temperature and humidity, if the temperature is under great change, condensation of moisture may sometimes
occur and measurement errors may appear when thermocouple is inputted. In such situation, please adapt to the
surrounding environment for over 1 hour before using the instrument.
* If the instrument is used under high temperature for a long time, the service life of LCD may be shortened
(reduction of image quality, etc.). Please try not to use the instrument under high temperature (above 40°C
approximately).
-----------------------------------------------------------------------------------------------------------------------------------------
Please do not install the instrument at the following places:
●
Please choose the places with small temperature change and approximate to the normal
temperature
(23
℃
) to install the instrument. If the instrument is installed at the places that can be directly shined by sunlight or
places near thermal appliances, then bad influences may be imposed on the inside part of the instrument.
●
Places with surplus oil smoke, steam, humid gas, dust, corrosive gas, etc.
Oil gas, steam, humid gas, dust, corrosive gas, etc. may impose adverse effects on the instrument.
●
Places near galvanomagnetic generating sources
Please do not make magnetic appliances or magnets close to this instrument. If the instrument is installed
near the generating sources of the strong electromagnetic field, the influences brought by the magnetic field may
result in display errors.
To avoid abnormal operation of the instrument, a distance above 20 cm should be kept from the instrument
when radiofrequency generator is used on the spot.
●
Places inconvenient to watch images
7-inch TFT true-color LCD is adopted for the display part of this instrument. For display contents cannot be
seen clearly from an extremely eccentric angle, so please install the instrument at the places where observers can
watch from the front face.
3.2.2 Installment Method
●
Installment dimensions (Unit: mm)
Automation www.ato.com [email protected] Global Shipping +1 800-585-1519 (Toll-free)
Paperless Recorder
