ATN Zebra 16, Operator'S And Safety Manual

Page: 32 / 80

OPERATOR AND SAFETY MANUAL
32
1NO0035UK-05
Zebra 16
16- Overload Indicator:
This light flashes when the work platform's load capacity is exceeded.
See Section 5.2
–Load control.
16- Engine fault indicator:
This light comes on ignition and must go out when the engine starts.
When the engine is running, the light flashes if there is an alternator fault
(the alternator is no longer correctly recharging the battery).
When the engine is running, this light comes on steady when the diesel
engine oil pressure is abnormally low or when the cooling fluid
temperature is abnormally high: CUT the diesel engine as quickly as
possible.
See 4.2.3
– Diesel engine safeties.
16- Validation light:
This light is on when the validation pedal is activated and a movement
may be commanded.
16- System fault / Maintenance indicator:
This light flashes slowly when a service / pre-scheduled maintenance
operation is required.
This light is on steady (and an alarm sounds) if there is a control system
fault. See 5.2.3
– System fault.
16- Fuel level indicator:
This indicator lights up when the fuel level in the tank reaches a critical
level: add fuel in the tank.
See 7.1.2
– Fuel.
16- Preheat indicator:
This light comes on during the preheating phase and goes off once the
engine starts.
See Section 4.2
– Diesel engine operation.
DANGER
IF THIS LIGHT COMES ON AND AN ALARM SOUNDS WHEN THE WORK PLATFORM
IS RAISED, IMMEDIATELY LOWER THE PLATFORM, STARTING BY BRINGING THE
TELESCOPE BACK IN.