ATN Zebra 16, Operator'S And Safety Manual

Page: 46 / 80

OPERATOR AND SAFETY MANUAL
46
1NO0035UK-05
Zebra 16
S
S
S
e
e
e
c
c
c
t
t
t
i
i
i
o
o
o
n
n
n
6
6
6
.
.
.
E
E
E
M
M
M
E
E
E
R
R
R
G
G
G
E
E
E
N
N
N
C
C
C
Y
Y
Y
P
P
P
R
R
R
O
O
O
C
C
C
E
E
E
D
D
D
U
U
U
R
R
R
E
E
E
S
S
S
6.1. EMERGENCY CONTROLS
The emergency commands must only be used by personnel with detailed knowledge of the
machine's operating characteristics and the ground control functions.
If the platform is jammed or stuck in a structure or equipment at height, stop operating the
machine immediately. Use other equipment to rescue the platform's occupants. Stabilise the
machine before you try to clear it. Make sure you do not control any movements that might lead
to the machine tipping over.
6.1.1 EMERGENCY STOP
Each control station has an emergency stop button that stops the machine's movements and
cuts the diesel engine when it is pushed in.
6.1.2 CONTROL STATION ON THE GROUND
The priority control station on the ground is used to raise or lower the platform in the event of
an emergency, when the operator on the work platform is unable to operate the machine.
1- Set the control station selector to "ground control station ".
2- Start the diesel engine.
3- Check that there are no obstacles at height that might interfere
with the machine’s
movements
4- Activate the appropriate controls to raise or lower the platform.
6.1.3 AUXILIARY HYDRAULIC GROUP
In the event of a breakdown on the diesel engine, an auxiliary group is used to power the
machine's hydraulic circuit to return the platform to its low position. The hydraulic group is
powered by the diesel engine's start-up battery. It may be used from the control station on the
ground or from the work platform's control station. The auxiliary hydraulic group may only be
used when the diesel engine is stopped.
•
From the ground control station
1- Activate and hold down the validation button. When the diesel engine is stopped, the
validation button enables the auxiliary hydraulic group to run.
2- Use the commands to take the platform back to low position.
•
From the work platform control station
1- Press the validation pedal.
2- Keep the Start / Auxiliary Group button tilted downwards.
3- Use the commands to take the platform back to low position.