ATN Zebra 16, Operator'S And Safety Manual

Page: 37 / 80

OPERATOR AND SAFETY MANUAL
1NO0035UK-05
Zebra 16 37
DANGER
WHEN THE PLATFORM IS RAISED,
ONLY USE THIS CONTROL TO MAKE A
SLIGHT LEVEL CORRECTION.
INAPPROPRIATE
USE OF THIS
CONTROL MAY RESULT IN OBJECTS
OR
PERSONS ON THE WORK
PLATFORM FALLING OFF.
2- Tilt the telescope control lever to the right to take the telescope out. Tilt the telescope
control lever to the left to take the telescope back in.
3- To stop the movement, release the control lever or the enable button.
•
From the work platform control station
1- Select the engine speed required.
2- Activate the validation pedal.
3- Within 5 seconds, tilt the telescope command lever backwards to take the telescope out
and backwards to take the telescope back in.
The telescope movement speed may be adjusted using the speed adjustment gauge.
4- To stop the movement, put the lever/joystick into neutral to reduce the speed and release
the validation pedal.
4.4.4 LEVELLING THE PLATFORM
This command is used to adjust the platform's horizontal level when driving on a slope.
•
From the ground control station
1- Activate and hold down the validation
button. The validation button must be
activated before a movement is
commanded.
2- Tilt the levelling control switch upwards or
downwards to correct the work platform's
horizontal level in the corresponding
direction.
3- To stop the movement, release the
command lever or the validation button.
•
From the work platform control station
1- Activate the validation pedal.
2- Within 5 seconds, tilt the levelling command lever upwards or downwards to correct the
work platform's horizontal level in the corresponding direction.
3- To stop the movement, release the command lever or the validation pedal.
-NOTE-
Prohibiting this function when the work platform is raised may be configured in the
system: See §8.3.1 - Settings
4.4.5 STRUCTURE ORIENTATION
•
From the ground control station
1- Activate and hold down the validation button. The validation button must be activated
before a movement is commanded.
2- Tilt the orientation command lever up to move the structure to the right or down to move
the structure to the left.
3- To stop the movement, release the command lever or the validation button.