ATN Zebra 16, Operator'S And Safety Manual

Page: 27 / 80

OPERATOR AND SAFETY MANUAL
1NO0035UK-05
Zebra 16 27
7- Arm 2 Raise / Lower command:
Tilt the lever up to raise arm 2 or down to lower arm 2.
Note: we recommend that the telescope be taken back in first.
See Section 4.4.2
– Elevation.
8- Telescope In / Out command:
Tilt the lever to the right to take the telescope out or to the left to bring it
back in.
See Section 4.4.3
– Telescope.
9- Arm 3 Up / Down control:
Tilt the lever up to raise arm 3 or down to lower arm 3.
See Section 4.4.2
– Elevation.
10- Platform rotation control:
Toggle the switch upwards to move the platform to the right or downwards
to move the platform to the left.
See Section 4.4.6
– Work platform rotation.
11- Up / Down platform levelling control:
Toggle the switch up to adjust the platform level upwards or down to
adjust the platform level downwards.
See Section 4.4.4
– Platform levelling.
12- Overload indicator light:
This light flashes when the work platform's load capacity is exceeded.
See Section 5.2
–Load control.
12- Engine fault indicator light:
This light comes on power up and must go out when the engine starts.
When the engine is running, this light flashes if there is an alternator fault:
the alternator is no longer correctly recharging the battery.
When the engine is running, this light comes on steady when the diesel
engine oil pressure is abnormally low or when the cooling fluid
temperature is abnormally high: CUT the diesel engine as quickly as
possible.
See 4.2.3
– Diesel engine safeties.
12- Maintenance / System fault light:
This light flashes slowly when a maintenance / pre-scheduled
maintenance operation is required.
This light is on steady (and an alarm sounds) if there is a control system
fault. See 5.2.3
– System fault.