ATN Zebra 16, Operator'S And Safety Manual

Page: 14 / 80

OPERATOR AND SAFETY MANUAL
14
1NO0035UK-05
Zebra 16
•
Inspection and controls before start-up.
•
Risks related to using the machine near overhead obstacles, other moving machines,
holes, obstacles on the ground and tilt.
•
Risks related to using the machine near conductors or powered electrical equipment.
•
Use of an approved fall-protection mechanism.
•
Safety requirements related to a task or specific use of the machine.
2.1.2 INSPECTION OF THE WORKPLACE
•
Before using the machine, the operator must take precautions to avoid any risk in the
workplace:
- Note the hazardous locations in the working area.
- Note the overhead obstacles, the electrical lines, overheadcranes, cranes or other
elements.
- Note on the ground the presence of holes, bumps, tilt, debris and coatings likely to hide
holes or other dangers.
- Check that the ground is able to support the wheel load.
•
The machine must only be used in well-ventilated premises.
•
The machine must be used with sufficient ambient lighting.
•
The platform must not be raised if the machine is on the platform or trailer of a truck, on a
train, a ship or any other mobile or non-stabilised structure.
•
Do not operate the machine in hazardous environments unless approved for that purpose
by ATN.
•
DO NOT use the machine in presence of electromagnetic fields (radar, high voltage
currents…). This could damage the machine’s electronic components.
2.2. TIPPING HAZARDS
•
Never exceed the work platform's load capacity. Distribute the load evenly across the
platform floor.
•
Keep the load inside the work platform. Do not suspend a load from any part of the platform
or lifting structure. Do not place a load on the guard rail.
•
Check that the ground is able to support the maximum wheel load.
•
Do not drive the machine on slopes or tilts that exceed the maximum acceptable incline.
•
Do not raise the platform or move with the platform on inclines, hilly or loose surfaces.
Always make sure that the machine is on a firm and even surface before raising the work
platform or moving with the platform raised.
•
Keep the machine a good distance from holes, bumps, tilt, debris and coatings likely to hide
holes or other dangers on the ground.
•
Do not raise the work platform if the wind speed is greater than 12.5m/s (45km/h).
•
c.