12
13
Table 2-1. Description of Face Recognition Terminal
No.
Name
1
USB Interface
2
Card Swiping Area
3
Touch Screen
4
Camera
5
IR Light
6
White Light
7
Thermographic Module
8
IR Light
9
Camera
10
TAMPER
11
Thermographic Module Interface
12
Debugging Port
13
Power Interface
14
Wiring Terminals
15
PSAM Card Slot (Reserved)
16
Network Interface
C H AP T E R 3 . I N S TA LL AT I O N
3.1. INSTALLATION ENVIRONMENT
• Avoid backlight, direct sunlight, and indirect sunlight .
• For better recognition, there should be light source in or near the installa-
tion environment .
• Indoor and windless environment use only .
NOTE
For details about installation environment, see Tips for Installation
Environment.
3.2. FLUSH MOUNTING
Steps
1 . Install a gang box .
2 . Connect the thermographic module and the main body .
Figure 3-1. Connect Thermographic Module
3 . Use 5 supplied screws (4_KA4
×
22-SUS) to secure the mounting plate on
the gang box .
4 . Route the cable through the cable hole of the mounting plate and connect
to corresponding external devices’ cables .
5 . Align the device with the mounting plate and hang the device on the
mounting plate . Make sure the two sheets on each side of the mounting
plate have been in the slots at the back of the device .
Figure 3-2. Install Device
