Atmel ATDH2200E, User Manual

Page: 23 / 27

In-System Programming (ISP) Using Atmel’s ATDH2200E Configurator Programming System
ATDH2200E Programming Kit User Guide 3-5
1417E–CNFG–4/05
3.5 Using a
Configurator
with Altera
®
FPGAs
Perform the hardware and software setup as described in paragraphs 3.1 and 3.2.
3.5.1 Programming the
Contents of a .POF
or .RBF File into
AT17 Devices Note: Altera
®
Quartus
®
II users should use the .rbf file.
1. Procedure
➞
Select “/A: Convert, partition, program and verify from an
Altera file”.
2. Input File
➞
<design>.<pof | rbf>.
3. Output File
➞
Defaults to <CPS_INSTALL_DIRECTORY>\out.bst or the most
recently used output filename.
4. Options
➞
Default or previous settings are given. You may need to modify
the following:
– EEPROM Density
➞
Select the device density.
– Reset Polarity
➞
Select the reset polarity.
– A2 Bit Level
➞
Select “Specify before each device”
(2)
.
5. Press “Start Procedure”
(1)
.
3.5.2 Converting and
Partitioning the
Contents of a .POF
or .RBF File Note: Altera
®
Quartus
®
II users should use the .rbf file.
1. Procedure
➞
Select “/B: Convert and partition an Altera file”.
2. Input File
➞
<design>.<pof | rbf>.
3. Output File
➞
Defaults to <CPS_INSTALL_DIRECTORY>\out.bst or the most
recently used output filename.
4. Options
➞
Default or previous settings are given. You may need to modify
the following:
– EEPROM Density
➞
Select the device density.
5. Press “Start Procedure”.
3.5.3 Reading the
Contents of the
Configurator to
a *.BST File 1. Procedure
➞
Select “/R: Read data from device and save to an Atmel file”.
2. Output File
➞
Defaults to <CPS_INSTALL_DIRECTORY>\out.bst or the most
recently used output filename.
3. Options
➞
Default or previous settings are given. You may need to modify
the following:
– EEPROM Density
➞
Select the device density.
– FPGA Family
➞
Select “AT6K/Other”.
– A2 Bit Level
➞
Select the level that matches the level seen on the A2 pin of the
target device.
4. Press “Start Procedure”
(1)
.
Notes: 1. If CPS is being launched for the first time, the clock calibration dialog will
appear. Press “Yes” to proceed and select “High” for accurate calibration.