Stand-alone Device Programming Using Atmel’s ATDH2200E Configurator Programming System
2-8
ATDH2200E Programming Kit User Guide
1417E–CNFG–4/05
2.6
Using a
Configurator
with Cypress
®
FPGAs
Perform the hardware and software setup as described in paragraphs 2.1 and 2.2.
2.6.1
Programming the
Contents of a *.HEX
File to AT17 Devices
1.
Procedure
➞
Select “/CP: Convert, partition, program and verify from a
Cypress file”.
2.
Input File
➞
<design>.< hex>.
3.
Output File
➞
Defaults to <CPS_INSTALL_DIRECTORY>\out.bst or the most
recently used output filename.
4.
Options
➞
Default or previous settings are given. You may need to modify
the following:
– EEPROM Density
➞
Select the device density.
– Reset Polarity
➞
Select the reset polarity.
– A2 Bit Level
➞
Select “Low”.
5.
Press “Start Procedure”
2.6.2
Converting and
Partitioning
a *.HEX File
1.
Procedure
➞
Select “/CB: Convert and partition a Cypress file”.
2.
Input File
➞
<design>.<hex>.
3.
Output File
➞
Defaults to <CPS_INSTALL_DIRECTORY>\out.bst or the most
recently used output filename.
4.
Options
➞
Default or previous settings are given. You may need to modify
the following:
– EEPROM Density
➞
Select the device density.
5.
Press “Start Procedure”.
2.6.3
Reading the
Contents of the
Configurator to
a *.BST File
1.
Procedure
➞
Select “/R: Read data from device and save to an Atmel file”.
2.
Output File
➞
Defaults to <CPS_INSTALL_DIRECTORY>\out.bst or the most
recently used output filename.
3.
Options
➞
Default or previous settings are given. You may need to modify
the following:
– EEPROM Density
➞
Select the device density.
– FPGA Family
➞
Select “AT6K/Other”.
– A2 Bit Level
➞
Select “Low”.
4.
Press “Start Procedure”
2.6.4
Verifying the Device
against a *.BST File
1.
Procedure
➞
Select “/V: Verify device against an Atmel file”.
2.
Input File
➞
<design>.bst.
3.
Options
➞
Default or previous settings are given. You may need to modify
the following:
– EEPROM Density
➞
Select the device density.
– FPGA Family
➞
Select “AT6K/Other”.
– A2 Bit Level
➞
Select “Low”.
4.
Press “Start Procedure”
Note:
1. If CPS is being launched for the first time, the clock calibration dialog will
appear. Press “Yes” to proceed and select “High” for accurate calibration.
Summary of Contents for ATDH2200E
Page 1: ...ATDH2200E Programming Kit User Guide ...
Page 2: ......
