AT-OME-TX21-WP-E
34
The Web GUI
RS-232 page
Zone
If the AT-OME-TX21-WP-E is connected to another HDBaseT device, each of these drop-down list boxes are used to
set the serial port settings for the HDBaseT port on the corresponding device.
The available settings for each drop-down list can be found in the table, above. Click the
Save
button, next to the
Zone
settings, to commit changes.
TX RS-232
When the AT-OME-TX21-WP-E is connected to the AT-HDVS-200-RX, the drop-down list boxes will be disabled and
the HDBaseT baud rate will be locked at 115200.
If the AT-OME-TX21-WP-E is connected to another HDBaseT device, such as the AT-UHD-CLSO-824, each of these
drop-down list boxes can be set to the baud rate of the HDBaseT RS-232 settings on the corresponding device.
Click the
Save
button to accept the settings.
Setting
Description
Baud rate
Sets the baud rate. The following options are available: 2400, 9600, 19200, 38400,
56000, 57600, 115200.
Data bit
Sets the number of data bits used to represent each character of data. The following
options are available: 7 or 8.
Parity
Sets the parity bit, which can be included with each character to detect errors during
the transmission of data. The following options are available: None, Odd, or Even.
Stop bit
Sets the stop bit. Stop bits are sent at the end of each character, allowing the client
to detect the end of a character stream. The following options are available: 1 or 2.
