AT-OME-TX21-WP-E
16
Installation
Use the
IPStatic
and
IPDHCP
commands to switch between DHCP and IP mode through RS-232 or Telnet.
Refer to API documentation for more information. All commands and their arguments are case-sensitive.
• Setting static IP mode
1.
Connect to the AT-OME-TX21-WP-E using RS-232 or Telnet, through a compatible receiver.
2. At the command line, execute the
IPDHCP
command using the
off
argument, as shown.
IPDHCP off
3. Execute the
IPStatic
command. This command requires three arguments: the desired IP address of the
AT-OME-TX21-WP-E, the subnet mask, and the gateway address. All arguments must be entered in dot-
decimal notation. The following is an example:
IPStatic 192.168.1.112 255.255.255.0 192.168.1.1
• Setting DHCP mode
1. Connect to the AT-OME-TX21-WP-E using RS-232 or Telnet.
2. At the command line, execute the
IPDHCP
command using the
on
argument, as shown. All characters are
case-sensitive.
IPDHCP on
Once DHCP is enabled, the unit will be assigned an IP address by the DHCP server (if present).
The
System page (page 37)
, in the web GUI, allows the AT-OME-TX21-WP-E to use either DHCP or static IP mode.
The web GUI is accessed through the connected receiver. In order to access the web GUI, the IP address of the AT-
OME-TX21-WP-E must be known.
1.
Open the desired web browser and enter the IP address of the AT-OME-TX21-WP-E.
2.
Log in, using the required credentials. The factory-default username and password are listed below:
Username:
admin
Password:
Atlona
3. Click the
System
tab.
4. Click the
IP Mode
toggle to switch between the
DHCP
and
STATIC IP
setting. When set to
STATIC IP
, the
IP
,
Netmask
, and
Gateway
fields can be modified.
5. Click the
Save
button to save the changes.
IP address
Subnet mask
Gateway
Using the Web GUI
Using Commands
