Atlas Copco Dynapac F1000W T4i, Operation & Maintenance Manual

Page: 183 / 240

F 4.0 5
F_4.0_0
1_US.
fm 5-
6
Auger bevel gear (on the RH and LH
sides) (4)
- To check the oil level unscrew the in-
spection / filling plug (A).
NOTE:
The oil level is full when the oil is at the
lower edge of the inspection port or a lit-
tle oil flows from the hole.
To add oil:
- Remove the inspection / filling plug
(A).
- Add the proper oil through port (A) un-
til the oil level reaches the lower edge
of the inspection hole (A). Use only ap-
proved oil.
- Replace the inspection / filling plug
(A).
To change the oil:
NOTE:
Change the oil when the engine is at op-
erating temperature.
- Remove the inspection / filling plug (A)
and the drain plug (B).
- Drain the oil.
- Return the oil drain plug (B) and tighten.
- Fill oil, using an approved fluid, through the filling port (A) until the oil level reaches
the lower edge of the inspection hole (A).
- Replace the inspection / filling plug (A).
Keep the work area clean. Clean any spills!
A
B