Atlas Copco Dynapac F1000W T4i, Operation & Maintenance Manual

Page: 135 / 240

D 4.0 5
D_
4.1_0
1_US.f
m 5-2
6
1.1 Starting the paver
Before starting the paver
Before starting the diesel engine and beginning operation, the following steps must
be performed:
- Daily maintenance of the paver (see chapter F)
Check the operating hours counter to determine whether or not additional mainte-
nance work (such as monthly or yearly maintenance) must be performed.
- Check the safety devices and protective devices.
“Normal” starting
- Set the drive lever (20) to the center position and the speed preselector (12) and
the selector (21) for traction drive / engine to minimum.
- Insert the ignition key (10) in position “0”. The lights should be switched off during
starting to reduce the current drain on the battery.
Starting is not possible if the drive lever is not in the central position or if the emer-
gency stop button (40) is depressed,
- Turn the ignition key (10) into position 3 to start the engine. Once engine has start-
ed, release the key and it will spring-return to the “On” position. Do not let the starter
run continuously for more than 20 seconds; wait 1 minute before turning the starter
again.