Atlanta Attachment Company 1393E, Technical Manual & Parts Lists, Page: 48 / 60

d.- close the safety doors and press CLOSE IN FEED ROLLER from the loading menu.
e.- Press PREV MENU to Return to the Main menu
c.- Panel Cutting
a.- Set the table Lift switch to “Up” and remove
the re-winder shaft
b.- Make sure machine is loaded with material and
all doors are close
c.- Press
CONTROL POWER START from the
Main Menu Screen
d.- Press
PANEL MODE on the same screen.
e.- Load the production required (Panel quantity,
dimensions, etc.)
f.- Press
RUN .
“ATTENTION “Never leaves the machine unattended”
d.- Border Cutting
a.- Carefully adjust manually the cutting blades to the
right border width.
b.- Set the table Lift switch to “down” and install the
re-winder shaft
b.- Make sure machine is loaded with material and all
doors are close
c.-.- Press
CONTROL POWER START from the
Main Menu Screen
d.- Press
BORDER MODE on the same screen.
e.- Load the production required (Border quantity,
length, etc.)
f.- Press
RUN .
g.- Readjust the re-winder air pressure if required.
“ATTENTION “Never leaves the machine unattended”
From
the
library
of:
Diamond
Needle
Corp