Atlanta Attachment Company 1393E, Technical Manual & Parts Lists

Page: 49 / 60

Technical Manual & Parts Lists
2.4.- Maintenance
a.- Daily
1.- Drain water from water trap in air pressure
regulator.
2.- Clean any lint or debris from around bearings,
blades and motors.
3.- Clean work area and check for any signs of
abnormality or wear.
b.- Weekly
1.- Clean dancer bar guide chains and sprocket.
2.- Clean lint and debris from inside machine
around X-Cut linear rail bearings and belt.
3.- Clean lint and debris from Right & Left Trim blade bearing
rails and belts.
4.- Clean panel width sensors.
5.- Check for any areas of wear or potential problems.
c.- Monthly
1.- Thoroughly clean machine inside and out.
2.- Check condition of all drive belts.
3.- Check security of all blades.
4.- Check setting of blade sharpening stones.
5.- Clean threads from around all shafts and rollers.
6.- Clean cabinet cooling fan and filter.
7.- Check condition of dancer bar guide chain and
sprocket alignment on both sides..
8.- Check and grease pillow block bearings as needed. (Look for rust or fine metal particles)
A
B
B
FAN
FILTER
From
the
library
of:
Diamond
Needle
Corp