ATEN CS1842, User Manual, Page: 43 / 88

Chapter 4. Hotkey Operation
31
Mouse Port Switching
Mouse Port Switching allows you to switch ports using mouse wheel button
(clicked twice). For Mouse Port Switching to work, Mouse Emulation must be
enabled. To enable/disable mouse port switching, do the following:
1. Invoke HSM (see page 26).
2. Press
[W]
.
N-Key Rollover Keyboard Supporting Function
To enable/disable N-key rollover keyboard supporting function, do the
following:
1. Invoke HSM (see page 26
).
2. Press [K] [Enter] .
Switching Mode Selection
The Switching Mode Selection allows you to select an appropriate switching
mode between Normal Switching Mode and Fast Switching Mode.
Note: 1. This hotkey is only supported by CS1842 / CS1844 using firmware v.
1.1.101 or later.
2. The function (press a port selection pushbutton twice to bring the
audio focus to the computer attached to its corresponding port) will
be disabled when the fast switching mode is enabled, see
Alternative
Manual Port Selection Settings , page 19.
1. Invoke HSM (see page 26).
2. Press
[P]
.
3. Press and release the appropriate Function key (see table below).
4. Press [Enter] . After completing this procedure, you automatically exit
HSM.
Note: The configuration of Fast Switching Mode might not work with some
monitors. If your video output does not display successfully or work
properly, please use the default Normal Switching Mode instead.
Function Key Operation
1 Sets the KVM to Normal Switching Mode (Default).
2 Sets the KVM to Fast Switching Mode.