[27]
Please connect the 3-‐wire 4-‐20mA Sensor
according to the Connection Diagram below,
while the instrument is OFF
1) Press and hold button, and
while holding button
press button at the same time
Please follow the steps below to
calibrate the 4-‐20mA Output Sensor
QUICK 3-‐WIRE 4-‐20mA OUTPUT SENSOR CALIBRATION GUIDE
2) Press button
prog
˝Inpvt
sensor
3) Press 2 times
button
4-20nA
5) If you don’t see “
4-20nA
”,
use buttons until you see it,
then press button to save
4) If you see “
4-20nA
” in the display,
press button to save, and
go to step (6)
9) Press 2 times button
8) Press button
6) Press 2 times button
˝Inpvt
7) Press 2 times button
˝CaLIb
SCL-Lo
10) Use buttons until
you see “
0
” in the display
11) If you see “
0
” in the display,
press button to save
in the display
0
19) Press 2 times button, to go back to Operating Mode
18) Press button to save
14) After you enter full range output in the display,
press button to save
SCL-HI
CAL-Lo
12) Press 2 times button
100
13) Enter Sensor’s full range output value here,
using buttons (e.g. 10bar, 500bar etc.)
15) Press 2 times button
avtoCL
16) Press button
OFF
17) Press button
On
