[24]
19) Press 2 times button, to go back to Operating Mode
14) After you enter full range in the display,
press button to save
16) While the display is flashing “SET”, adjust your
potentiometer to 0mm position, and press button
18) While the display is flashing “SET”, adjust your
potentiometer to full range position, and press button
9) Press 2 times button
8) Press button
2) Press button
1) Press and hold button, and
while holding button
press button at the same time
6) Press 2 times button
prog
˝Inpvt
sensor
3) Press 2 times
button
LInpot
5) If you don’t see “
LINPOT
”,
use buttons until you see it,
then press button to save
4) If you see “
LINPOT
” in the display,
press button to save, and
go to step (6)
˝Inpvt
7) Press 2 times button
˝CaLIb
SCL-Lo
SCL-HI
CAL-Lo
CAL-HI
10) Use buttons until
you see “
0
” in the display
11) If you see “
0
” in the display,
press button to save
in the display
0
12) Press 2 times button
100
13) Enter Potentiometer’s full position range here,
using buttons (e.g. 100mm, 500mm etc.)
15) Press button
SET
17) Press button
SET
QUICK POTENTIOMETER CALIBRATION GUIDE
Please connect the Potentiometer according
to the Connection Diagram below,
while the instrument is OFF
Please follow the steps below to
calibrate the Potentiometer
