2. Changing the saw blade
1.
Power off (unplug) the saw.
2.
The machine on the front panel (FIGURE 1 NO.17) as a complete open door unlocking. cover at the rear of the
machine (FIGURE 2 No.1-3) Open by removing the screws.
NOTE : Make sure not to damage the components inside the cabinet.
3.
Remove the cover of the housing by removing the four Butterfly nuts located on the saw protective enclosure
(FIGURE 3 NO.34-22). (FIGURE 3)
4.
Remove the M10 screw (FIGURE 3 NO.34-22) with the help of an 8 mm Allen wrench. When removing the bolt
hold saw shaft (FIGURE 4 NO.34-5) from the other end with a 19 mm wrench.
5.
Remove the string (FIGURE 3 NO.34-28) and saw coupling (FIGURE 3 NO.34-27) respectively.
6.
Take out the saw blade (FIGURE 3 NO.34-26) carefully and bring it to the service door at back side of the ma-
chine.
7.
Install the new saw blade onto the shaft ensuring the correct rotation direction.
8.
Install the guard group parts applying the reverse order as described above.
9.
It is necessary to sharpen / replace the saw blade in certain intervals depending on the cutting material. If the
cut material leaves burr after the cutting operation or if the saw blade is strained, it needs to be sharpened /
replaced.
31
Summary of Contents for ACK700
