ATECH ACK700, User Manual

Page: 28 / 38

2. Operation
1. Switch the system start switch to “1” (FIGURE 1 NO.17-3)
2. Open the top guard (FIGURE 1 NO.51) by pressing the button (FIGURE 1 NO. 17-4-1) on the control panel. The
top guard operates pneumatically.
3. It is possible to make a straight or miter cuts on this machine. 0-15 - 22.5 - 30 - 45 -60 and 75 degrees can be
adjusted with the help of a safety catch (FIGURE 2 NO.27), and the other interim degrees with the help of a
special clamping screw (FIGURE 2 NO.31). The safety catch is not seated in the slot in interim degrees. Tighten
the clamping screw after turning the turntable (FIGURE 2 NO. 14) to a special degree you desire.
4. In order to make a miter cut pull the rod of the safety catch (FIGURE 2 NO.27) out of the slot of the safety catch.
Simultaneously move the turntable (FIGURE 2 NO.34) with your other hand to a degree you want with the help
of plastic handle (FIGURE 2 NO.34-1). You can read the angle values with the help of a degree reader (FIG-
URE 2 NO. 28) on the table (FIGURE 2 NO.26).
5. In order to provide the right or left movement of the movable set square (FIGURE 2 NO.37) loosen the fixing
pipe (FIGURE 2 No.36) by turning half-round. Towards the right or left direction of the movable set square after
completing the movement, provide the parallelism of the movable set square against each other in both of the
set squares with the help of the setscrews on the fixed set square (FIGURE 2 NO. 35). After finishing all of the
settings fix the set squares by tightening the fixing pipes.
Distance between set screws can not be less than table channel’s dimension. (Dimension of
TABLE CHANNEL is 8 mm.)
28