Atec 8000, Operation And Maintenance Manual, Page: 27 / 80

Atmospheric Technology 21
6. Local Area Network Connection
If the sampler is to be connected to a local area network (LAN), the following steps
will need to be taken to enable communication between the sampler and a PC or
tablet on the same LAN.
6.1 Initial Network Setup
Before communication is started, the IP addresses of the sampler and the remote
PC/tablet must be determined. This will insure that only these devices can
communicate and other devices will be locked out. The remote PC/tablet must also
have a copy of “VNC Viewer” for communicating (enclosed on jump drive). This
software is available on the internet. The following steps need to be done only once
unless noted.
1. Connect the PC/tablet and the sampler to the LAN.
2. On the PC/tablet, bring up the “command prompt” window.
•
Type:
ipconfig
• Record the IP Address that appears under the Ethernet Adapter
setting: Autoconfiguration IPv4 Address. This is the “Remote IP
Address”.
3. On the Sampler, go to the Setup screen. The IP Address for the sampler will
be in the text box with the label “Local IP Address”.