Installation Self-Test
Upon installation, the Power and Pass LEDs on each radio module will light. The radio
module(s) then initiate a 2-minute self-test and synchronization. If a radio module’s Pass
LED does not light, repower the module or its carrier. Refer to “Troubleshooting” later in
this booklet if the LED still does not light.
NOTE:
The Radio LED also may light upon installation; however, since the Radio LED has no
significance during the self-test, ignore its operation.
The Radio LED indicates a connection between the handset and the radio module; it
lights when the handset is being used as long as the battery pack in the handset is
charged.
Installing the MDW 9010
2-25
