Yes
No
[31] Was first
or third scope
selected
to be used by repeating
With No High Frequency Noise
Vert
=
0.5V/DIV, Hor
=
0.02
µ
s/DIV
Vert
=
0.5V/DIV, Hor
=
0.02
µ
s/DIV
1.9V PEAK-TO-PEAK
MEASURED TO
CENTER OF FAT
PORTION OF
SIGNAL AT PEAK
With High Frequency Noise
FIG. 4 — Correct 1.9V Peak-to-Peak Reading
FIG. 3 — Correct 1.9V Peak-to-Peak Reading
[33] Calibrate channel 1
and channel 2 with probes
Steps 4 through 13 for
each channel using
calibration source chosen
in Step 15
[32] Calibrate channel 2
of scope selected (first
or third) with probe
from other scope by
calibration source chosen
in Step 15, Page 2
[34] See NOTE 2,
Refer to FIG. 3
and 4 for correct
reading of 16-MHz
clock signal
repeating Steps 4,
width. Connect
probe to terminal
adapter. Never use
connect probe to
terminal. Always
High frequency
directly or use
measurement
CAUTION 2
less) probe ground
lead
verifies that
oscilloscope is
calibrated and set
to full band-
cliplead to
SAFELEED
test lead
use short (4" or
[30] Note amplitude
and select scope
that disagrees
CALIBRATE SCOPE
least with
other two scopes
DLP
PAGE 4 of 4
234-151-013
529
Issue 8
DEC 1995
