ASUS PCI-DA2000 Series RAID Controllers Driver Installation
69
8. SCO Unix Driver Installation
8. SCO Unix Driver Installation
The chapter describes how to install SCO UNIX BTLD (Boot Time Loadable Driver)
for ASUS PCI-DA2000 Series Controller.
8.1. Installing SCO UNIX
1
Use ASUS PCI-DA2000 Series BIOS Configuration Utility to disable ISA Mail-
box Emulation mode (default is disabled). To do this, at system bootup, press
[Ctrl-I], select Configure Card option, then change IO Port Address to DIS-
ABLED.
2
Use ASUS Text RAID Manager or RS-232 Terminal Interface Operation to con-
figure Logical Drives and SCSI Devices and map them to valid SCSI-IDs/LUNs.
Note that SCSI ID 7 is reserved for the ASUS PCI-DA2000 Series controller
and thus no logical drives or devices should be mapped to this SCSI ID.
3
Check IO devices, CD-ROM or TAPE drive is properly installed.
4
Insert the N1 boot diskette into the floppy drive and turn on the PC. When the
“boot” message appears, type link as follows:
SCO UNIX System V/386
Boot: link <Enter>
5
Type PCIDA at the following prompt:
What packages do you need linked in the system,
or ‘q’ to quit?: pcida
8. SCO Unix
Installation
