GigaX Series L2 Managed Switch User Guide
79
[Network Mask]
Displays the subnet mask for the switch.
CLI command:
net interface ip sw0
< IP address> <netmask>
[Default Gateway]
Displays the IP address of the default gateway. This field is necessary if the
switch network contains one or more routers.
CLI command
: net route static add
<destination subnet/IP> <gateway>
<netmask> <metric>
[Password Protection is] [Enabled/Disabled
]
When the password protection
is enabled, the web interface will request a user
name
and password authentication while user accesses the switch through the
browser.
CLI command :
sys web set
<enable/disable>
[New Password]
[Verify Password]
The default user name is
admin
. By default, a password is not
required. You
may set a password by configuring these fields.
CLI command :
sys users modify
<user name, ‘admin’ by default>
user name
(
old user name, ‘admin’ by default
)
: <new user name>
password
(old password,):
<new password>
[Reboot]
User can reboot the switch by issuing the reboot command.
CLI command
: sys reboot
[Upload]
No CLI command for this function. Refer to Boot ROM commands for this
function.
Summary of Contents for GigaX 2024X
