ASTRO VG-870, Instruction Manual

Page: 476 / 499

462
6.2 Setting and executing the H and V timing data
The command settings used from setting the H and V timing data to executing the data are listed
below.
Example: If the H and V timing data shown below are to be set in program No.0001 and executed,
then:
H Timing V Timing
μ/dot
1 SCAN MODE 0
Repetition 1 SERRATION 0 H
DotClock 65.00 MHz ENQ ON/OFF 0 H
H-PERIOD 1352 dots V-TOTAL 804 H
H-DISPLAY 1024 dots V-SYNC 4 H
H-SYNC 96 dots ENQ-FP 0 H
H-BACK-PORCH 202 dots ENQ-BP 0 H
HD-START 0 dot V-BACK-PORCH 29 H
HD-WIDTH 0 dot V-DISPLAY 768 H
VD-START 0 H
VD-WIDTH 0 H
V-TOTAL2 80 H
V-SYNC2 1 H
ENQ-FP2 0 H
ENQ-BP2 0 H
V-BACK-PORCH2 0 H
V-DISPLAY2 2 H
VD-START2 0 H
VD-WIDTH2 0 H
TvMode Other
Category1 to 32 0
Note) the above data set Scan Mode as
“0 (non-interlace)”. Therefore, only the 1
st field
data is available as field data. However, if you set all 0 in the 2
nd
field, it will show data
area check error. Therefore, the example sets the same data of the 1
st
field in the 2
nd
field.
1
st
field
2
nd
field