Programming using the HE programming software
Operating manual V 506 a. X-QAM 621 CT2 -
Version 10-2014A
Page 12
Configuring the DVB-T2 tuner
Figure 9: Input parameters for the DVB-T2 tuner
A
UFGABE
1.
Select the “DVB-T” entry from the
Tuner Mode
drop-down
menu.
2.
Select the desired channel or the special channel from the
Channel
drop-down menu.
3.
Enter the desired frequency in the
Frequency
input field.
4.
Select the desired bandwidth (6, 7 or 8 MHz) from the
Bandwidth
drop-down menu.
5.
You can optionally activate a 5 V remote power supply for a
connected DVB-T antenna by clicking on the
Remote supply
power (5 V)
checkbox.
E
RGEBNIS
:
The input parameters are now defined and you can check the signal
quality (see following section “Checking the input signal quality”).
Checking the input signal quality
The V 506 and X-QAM 621 CT2 plug-in cards feature a test function
for identifying the input signal quality. This gives you the opportunity
to carry out a quick check of the quality of the input signal being fed
to the tuner.
Proceed as follows to identify the quality of the input signal:
