TROUBLESHOOTING
40
SECTION 6
–
Troubleshooting
Troubleshooting Guide is provided to assist in solving any problems that might occur with the
Tabber. We tried to make it as complete as possible. The best advice is to make sure tabs, labels
or stamps are threaded properly and machine is plugged in and turned on.
Jams
CONDITION
SOLUTION
Media jams in transport section of Tabber.
1.
Check alignment of Feeder to
Tabber. Media should be fed between
1/8" to 1/32" away from Fixed Guide
in Tabber.
2.
Check that two Paper Guides are not
pressing down too firmly on media.
3.
Check that Adjustable Center Guide is
not pushing paper tightly against
Fixed Side Guide.
4.
Check that head pressure is not
too tight.
Tab Placement Problems
CONDITION
SOLUTION
Tabs are not placed in same spot on media.
Tabs should be placed /- 1/8"
1.
Check pitch setting for tab. It should
be slightly more than tab size plus
space between tabs.
2.
Check amount of head pressure.
Too little can cause media to slip
when it is being fed.
3.
Check that pointer on Applicator
Head is in center of tab.
More of the tab is on the top of the media
than on the bottom.
Adjust Fine Adjustment Knob (
Page 12
)
clockwise to move more of the tab to the
bottom side of the media.