OPERATING TABBER
10
Loading Tabs
1.
Remove Roll Side Guide and install tab roll with tabs unwinding face up from right side
of roll. Remove approximately 30 tabs from roll to create a leader.
2.
Release Unwind Drive Press Roller (
rotate it to the left
) and thread leader over Unwind
Drive Roller. Rotate Unwind Drive Press Roller so it contacts Unwind Drive Roller.
3.
Thread leader into Bin, then over Bin Idler Roller. Adjust Bin Roller Tension Spring so it
lightly touches tab backing.
4.
Continue threading leader under Idler Roller, then through slot in Tab/Label Sensor
and Applicator.
5.
Bring leader back up and under Idler Roller.
6.
Lift Drive Roller Cover and Drive Press Roller. Thread leader under Driver Cover Guide
Roller, over Drive Roller and under Drive Press Roller. Close Drive Roller Cover and
bring Drive Press Roller into contact with Drive Roller.
7.
Remove Side Guide from Take up Reel and thread leader through pins on Take-up Reel,
and then replace Side Guide.
8.
Make sure Adjustable Web Guides on Bin Idler Roller and Idler Roller lightly contact
edge of tab/label backing.