PROGRAMMING TABBER
32
6.
Remove approximately 30 labels from stack.
Then place stack on Label Tray. Adjust Side
Guide
[4]
to within 1/16" of labels.
7.
Thread labels over top of Tray, then down
through two Guide Rods
[5]
(
as shown
). Hook
Label Plate
[6]
over Top Guide and behind
Lower Guide, but in front of labels.
8.
Then continue threading labels in Tabber per
“Loading Tabs”
instructions.
To program job, refer to
“Program
Job
–
Single
Tab”
instructions.
Fan-Folded Labels Over 2" Long
CAUTION
WHEN RUNNING LABELS OVER 2" LONG, TABBER SPEED MUST BE SET
TO 10,000 PIECES PER HOUR OR LESS.
Install Long Fan-Folded Label Tray to run fan-folded labels over 2" long (
up to 4" long
)
on Tabber.
Steps required are below:
1.
Remove any labels or tabs that may be installed
on Tabber.
2.
If Labels are Over 2" Wide (
up to 4" Wide
):
Replace 2" Tab/Label Applicator Head with
4" Tab/Label Applicator Head.
3.
Remove Roll Guide
[1]
and Roll Core Support
[2]
from Tabber. Roll Core Support is held in place
by an Allen screw.