ASSEMBLY AND INSTALLATION
7
Installation
Choose a Location
Place Tabber with its Feeder on a level sturdy worktable or cabinet at least 12" from any
walls.
IMPORTANT:
Allow enough room to place Feeder and Feeder Base on the same
work surface. Protect Tabber from excessive heat, dust, and moisture
–
avoid placing it in
direct sunlight.
Plugging in Printer
Make sure
Emergency Stop Switch
is turned OFF.
1.
Connect one end of power cord to rear of Tabber in
corresponding receptacle.
2.
Plug other end into a 115-220 Volt AC, 50/60 Hz.
grounded outlet.
CAUTION
DO NOT USE ADAPTER PLUGS OR
EXTENSION CORDS TO CONNECT TABBER
OR FEEDER TO WALL RECEPTACLE.
DO NOT USE OUTLETS CONTROLLED BY
WALL SWITCHES.
DO NOT USE AN OUTLET THAT SHARES
THE SAME CIRCUIT WITH LARGE
ELECTRICAL MACHINES OR APPLIANCES.
FF-14 Feeder and Feeder Base
Install Feeder Base Guides
Before using the FF-14 Feeder, install the Feeder Guide Kit included with the Tabber.
Tabber Feeder Guide:
1.
Remove protective tape from Guide.
Remove two screws
[A]
on the feed end of
the Tabber.
2.
Align the Tabber Feeder Guide
[B]
with
holes in the Tabber.
3.
Attach the Feeder Guide using screws
removed in
Step 1
.