Astria.US.com
126797-01F
8
Figure 7 - Installing Hood
Figure 8: Installing Bi-Fold Glass Door
Insert Bottom
Pivot Pin into
Pivot Plate or
Hole and Swing
Door into a
Vertical Position
Fold
Door and
Slide Top
Pins into
Track
Spring Clip
Insert Pin
into Spring
Clip
Pivot Plateor
Pivot Hole
INSTALLING FIREPLACE HOOD HS36/HS42
1. Remove protective fi lm from stainless hood.
2. Align three mounting holes located on back side of hood with
front face of fi replace
(see
Figure 7
).
Mounting holes should
be at least 2" up from edge of fi replace opening.
3. Hold fi replace hood in place. Using a 1/8" (0.125 dia.) drill
bit, drill through 3 mounting holes.
4. Insert 3 screws through mounting holes in hood into holes
in fi replace.
INSTALLATION
Continued
INSTALLING BI-FOLD GLASS DOORS
IMPORTANT: Use only glass doors certifi ed for use
with this fi replace
(See Accessories, Page 24).
Door Installation
Pivot and spring clips have been installed and pretested at the factory,
but some readjustments may be needed due to movement during
shipping or handling.
Install doors using the following steps. If you fi nd doors do not close
properly or do not appear level or straight, proceed with section on
door adjustment.
1. With bi-fold door completely folded, insert bottom pivot pin into
pivot plate or pivot hole located near bottom corner of front face
opening and swing door to the vertical position making sure top
pins slide into door track. Door is installed when top door pin snaps
into spring clip
(see
Figure 8
).
2. Repeat step 1 for remaining door.
WARNING: Fireplace must be operated only with
doors fully opened.
Door Adjustment
Remove doors and slightly loosen lower pivot plate (if equipped)
and upper spring clips. Replace doors and fully close them. Use
1/8" shims (any material) to level doors. Once the proper setting is
achieved, carefully open doors enough so that you can access pivot
and spring clips with a Phillips screwdriver. Tighten screws
(see
Figure 9, Page 9
).
Please read the following care and operation guidelines before operat-
ing your appliance or fi replace.
• Glass doors should be operated in the fully open position only
(see
Figure 10, Page 9
).
• If doors are not fully open, the thermodisk will automatically turn
off burner. See Safety Device on
Page 15
for instructions on how
to reset the thermodisk.
• When operating doors, do not slam shut or abuse them.
• Always keep area below bottom edge of doors clear from obstacles
or debris.
• Do not operate this appliance if glass doors are broken or damaged.
• Do not use abrasive liquids or cleaners for cleaning of glass and
door trims. Any household glass cleaner should suffi ce. Do not
clean doors when hot, allow the appliance to cool before cleaning.
Mounting Holes
on Hood
Screws
