Astria.US.com
126797-01F
13
NOTE:
If pilot goes out, repeat steps 4 through 8.
9. Slightly push in and turn control knob counterclockwise
to the ON position.
10. Wait one minute and move switch to the ON po si tion to light
burner.
NOTE:
AUTO is only func tion al when using optional remote control
accessory.
11. Set fl ame adjustment knob to any lev el be tween HI and LO.
Figure 18 - Setting Control Knobs
Piezo Igniter
Control Knob
Flame Adjustment Knob
INSPECTING BURNERS
Check pilot fl ame pattern and burner fl ame patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper fl ame height.
Alterations may have occurred during shipping and handling. Call a
qualifi ed service person to readjust the pilot if necessary.
The height of the thermopile must be 3/8" to 1/2" above the pilot
fl ame as shown in
Figure 20
. The thermocouple must be at a height
of about 1/8" above the pilot fl ame. The fl ame from the pilot burner
must extend beyond both the thermocouple and thermopile.
If you pilot assembly does not meet these requirements:
• turn fi replace off (see To Turn Off Gas to Appliance)
• see Troubleshooting,
Page 16
BURNER AND PILOT FLAME PATTERNS
Figure 21
shows correct burner fl ame pattern.
NOTICE: Do not mistake orange fl ames with yellow
tipping. Dirt or other fi ne particles are burned by ap-
pliance, causing brief patches of orange fl ame.
If burner fl ame pattern is incorrect, as shown in
Figure 22
.
• turn appliance off (see To Turn Off Gas to Appliance)
• see Troubleshooting,
Page 16
OPERATION
Continued
TO TURN OFF GAS
TO APPLIANCE
1. Push switch into OFF position. The pilot will remain lit for normal
service.
2. Access control knobs.
3. Press gas control knob slightly and turn clockwise to OFF. Do not
force.
4. Close equipment shutoff valve
(see
Figure 14, Page 10
).
HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot before using the
hand-held remote control unit. See Lighting Instruc-
tions,
Page 12
.
After lighting, let pilot flame burn for about one minute. Turn
control knob to ON position. Adjust flame adjustment knob
anywhere between HI and LO. Slide the selector switch to
the REMOTE position on Remote Receiver
(see
Figure 19
).
NOTE:
The burner may light if hand-held remote was on when selector
switch was last turned off. You can now turn the burner on and off
with the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch in the REMOTE or ON
position when the pilot is not lit. This will drain the battery.
Figure 19 - Settings for Remote Operation
Selector Switch in
REMOTE Position
REMOTE
OFF
ON
Piezo Igniter
Control Knob
Flame Adjustment Knob
Figure 20 - Pilot Assembly Flame Pattern
Thermocouple
Thermopile
1/8"
Pilot Burner
Piezo Igniter
3/8" to 1/2"
Figure 21 - Correct Burner Flame Pattern
Figure 22 - Incorrect Burner Flame Pattern
Dark Orange
Flames
Yellow Flames with
Orange Streaks
