Astria.us.com
126776-01K
15
OPERATION
Figure 29 - Turning Equipment Shutoff Valve to the OFF Position
MAIN
IN
OUT
PILOT
ADJ
PILOT
Equipment Shutoff
Valve
Incoming Gas
Line
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
CAUTION: Do not try to adjust heating levels by
using the equipment shutoff valve.
FOR YOUR SAFETY
READ BEFORE LIGHTING
TO TURN OFF GAS
TO APPLIANCE
LIGHTING
INSTRUCTIONS
A. This appliance does not have a pilot, it is equipped with an
ignition device which automatically lights the pilot. Do not
light pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Do not use this appliance if any part has been under water. Imme-
diately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been under water.
This appliance requires 120V electricity for normal operation. Control
module should be plugged into electrical outlet located underneath
firebox bottom. Back up battery supply is available for power outages.
1. STOP! Read the safety information, column 1.
1. Push remote control to “OFF” position.
2. Turn off all electric power to appliance if service is to be performed.
3. Turn equipment shutoff valve clockwise
to OFF. Do not force.
4. Replace access cover.
Solid fuels shall not be burned in this appliance.
2. Make sure equipment shutoff valve is fully open.
3. Turn safety shutoff switch to the OFF position.
4. Remove access cover.
5. Turn equipment shutoff valve clockwise
to the OFF position
(see Figure 29). Do not force.
6. Wait five (5) minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow “B” in the
safety information. If you don't smell gas, go to the next step.
7. Turn equipment shutoff valve counterclockwise
to the ON
position. Do not force.
8. Replace access cover.
9. Turn on all electric power to appliance.
10. Turn safety shutoff switch to the ON position.
11. Visually locate igniter. Igniter should begin to spark and main
burner should ignite once flame appears at pilot.
• If lighting appliance for the first time each season, it may take
several attempts before supply gas can reach pilot and main
burners.
• If appliance will not stay lit after several attempts, follow instruc-
tions under To Turn Off Gas To Appliance and call your service
technician or gas supplier.