Astria.us.com
126776-01K
13
Figure 22 - Access Door for See-Thru Applications
Figure 23 - Removing Control Access Cover (Face Bottom
not shown for Clarity)
Figure 24 - Control Module (Face Bottom not shown
for Clarity)
Remove
Screws
Electronic Access
Cover
Backup
Battery
Remote
Receiver
Gas
Module
ON/OFF
Switch
Light
Switch
Access Door
Flange on Face
Bottom
Side
Filler
Installing Access Door
1. Place access door in front of fireplace opening with the slanted
side facing forward. The slanted surface will slide underneath the
flange of the bottom face Insert tabs on side of access door into
slots on retaining brackets (see Figure 22).
INSTALLATION
Continued
Installing Hood
1. Install hood as shown in Figure 15, Page 11.
Locating Control Module
1. Remove Access Plate (See Figure 22).
2. Remove 2 screws on top of the electronic access cover (See
Figure 23).
3. Remove electronic access cover by gently pulling up and out of
the fireplace. There are two switches connected to cover.
4. The control module is located on the left as shown in Figure 24.
5. Light switch is located on the right hand side as shown in Figure 24.
6. ON/OFF switch is located on the left hand side as shown in Figure 24.
Figure 25 - Placing Glass Pebbles
Place Glass
Pebbles on the
pebble tray in a
single orderly
layer.
Green glass pebbles are included with your fireplace. Install the glass
pebbles before installation of Draft Shield Kit, included.
1. Place glass pebbles in a single layer evenly on the pebble pan. Make
certain that the correct media is used. If crushed glass or other
media is used, replaced it with the proper media listed on the price
list. Make certain the media is placed precisely as indicated in this
instruction manual (single layer of pebbles in straight rows) and all
glass remains on the pebble tray with no glass at all on the burner.
WARNING: Do not change or substitute glass
pebbles provided with this fireplace. If replacing, use
only replacement glass pebbles. See Parts
Page 22
.
WARNING: Do not place the glass pebbles on
the burner, only on the burner tray as illustrated in
Figure 25
.
WARNING: Do not block pilot ports with glass
pebbles.
GLASS PEBBLE INSTALLATION