Asset ATLANTIS 120, Installation, User And Maintenance Manual

Page: 38 / 72

5-6
ATLANTIS - Installation, Use and Maintenance - Man cod.-02 - Rev. 02/2011
4. connect the free end of the tube to the water inlet
fitting positioned on the back side of the dispenser
5. open the interception valve to check that there are
no leakages from the fittings previously assembled.
6. It is suggested to carry out the dispenser sanitization
by using the appropriate kit (optional and not supplied
with the dispenser)
Water supply connections with a length longer than 4-5
metres must be realized with a greater section pipe. The
pipe delivered with the supply will be used just for the
connection to the water dispenser and to the optional ac-
cessories (filters, prefilters, etc.) which must be installed
in line with the mains.
5.4.6 Power supply connection
The dispenser is in accordance with the current EEC norms.
For this reason, it is marked with the CE symbol.
The Manufacturer declines any responsibility for possible
damage to persons or things due to connection of the
dispenser to electrical mains not in conformity with the
regulations and laws in force in the country where the
device will be installed. In particular, the electric mains
must be equipped with a high sensitivity circuit breaker
switch (cut-out switch), with tripping power not greater
than 30mA, and a grounding system in conformity with
the standards and regulations in force.
Anyway, it will be necessary to check that characteristics
of the power supply line are suitable for the dispenser,
as indicated in the technical data sheet.
In case the power supply cable is damaged, it must be re-
placed with a new one having the same characteristics.
Any attempt to repair the cable is forbidden!
After the required checks, it will be possible to insert the
female plug with trapezoidal section of the power cable
in the proper socket, in the back side of the dispenser
(fig. 5.9) .
fig.5.9