10
7300 Series
Installation Instructions
Multi-Point Lock
A8270A 02/20
Copyright © 2017, 2019, 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in
part without the express written permission of SARGENT Manufacturing Company is prohibited.
1-800-727-5477 • www.sargentlock.com
3
Installation (cont.)
h
Top and Bottom Latch Adjustment
• With the door hung, measure the clearance
between the top and bottom bolts and strikes.
(Figure 15)
Note:
If both measurements equal 1/16" proceed to Step
3i, otherwise proceed with Step 3h as follows:
• Remove the mortise filler cap and discard.
(Figure 16)
• Retract the latches by roting the lever and
opening the door. (Figure 17)
Figure 17
• Using the supplied 1/8" Allen wrench, loosen
the set screw 1/4 turn maximum. This allows
hex rods to rotate during the latch bolt
adjustment. (Figure 18)
Figure 15
1/16" Bolt to strike clearance.
TOP OF DOOR
1/16" Bolt to strike clearance.
BOTTOM OF DOOR
Figure 16
Note location
of set screws.
Figure 18
