SECTION VI DIAGNOSTICS AND TROUBLESHOOTING
- 6-14 -
6.2.3.2 Display Self Test
To initiate a test of the screen display, highlight
Display Self Test
and press [SELECT].
The following screen is displayed:
Press SELECT to start test.
Press MENU/EXIT to end test.
When [SELECT] is pressed, the display will start to cycle through 3 test screens:
a) All pixels on.
b) Alternating pixels on (checkerboard).
c) Reverse of b).
The test will randomly start in one of these three screens. Each screen lasts for about 7
seconds. Press [MENU/EXIT] to end the test and return to the Diagnostic Menu.
Note:
Display Self Test will not run in Battery Mode.
Summary of Contents for BISPECTRAL INDEX A-2000
