7
Power Jack:
To connect the DC 12V power adapter.
Network Connector:
The RJ-45 connector allows connect to the Ethernet network.
Micro-SD Card Slot:
Insert a Micro-SD card if you want to do the video recording in
the camera.
Terminal Block:
The terminal block provides the following functionalities:
Video:
The installed BNC connector allows connect to the
analog display to output analog video for locally monitoring.
MIC_IN:
Allows connect to a passive-type of microphone,
the audio will be heard at the remote site.
Line_OUT:
Allows connect to an amplified speaker, you can
hear the voice of the remote site from the speaker.
DI/ DO:
Digital In and Digital Out.
1. Refer to the next sections to connect the cable of Digital I/O, Audio output and MIC
input if you want to use these functionalities.
2. Connect Ethernet cable for network connection.
3. Connect power adapter to turn on the camera.
4. If the camera is PoE model, the power adapter is not necessary. The camera will get
the power from the PoE injector or PoE switch.
PoE (Power over Ethernet) is a technology that integrates power into a standard LAN
infrastructure. It enables power to be provided to the network device, such as an IP
phone or a network camera, using the same cable as that used for network connection.
It eliminates the need for power outlets at the camera locations. Please follow the
below figure for the connection.
PoE Switch or PoE Injector
Ethernet Cable
Data only
Ethernet Cable
Mixed data and power
PoE Network Camera
To Network
Summary of Contents for CAM6923F
