Asko TDC33, Service Manual

Page: 82 / 86

3
SELECT PROGRAM
Press one of the program buttons P1 to P8 .
P1 - Extra dry, normal temperature
P2 - Dry, normal temperature
P3 - Normal dry, normal temperature
P4 - Iron dry, normal temperature
P5 - Extra dry, low temperature
P6 - Dry, low temperature
P7 - Normal dry, low temperature
P8 - Iron dry, low temperature
Press the Start button to start
the drying program.
You can use the Stop button to interrupt a program.
Hold it pressed in for 3 seconds.
The word
Start
will appear on the display to show
that the drying program has begun.
2
LOAD DRYER
Press the power switch. The
display will light up.
NOTE! If you do not press a
button within 3 minutes the
display will be switched off. It
will light up again when you
press a button.
1
Start/Stop
P3
P1
P2
P4
P7
P5 P6
P8
Start/Stop
P3
P1
P2
P4
P7
P5
P6
P8
Stop
The program is complete
or has been interrupted.
Start
The program has started.
Program information
When you press P1 to P8 this field shows which
program is selected. While the program is running
it shows how far the cycle has progressed.
DRYING GUIDE
WHAT THE DISPLAY SHOWS
Symbol means that fabric can be tumble dried.
FABRIC WEIGHT TEMPERATURE
Whites, coloureds Cotton and (5.0 kg) Normal
and synthetics linen
Polyester/ (2.5 kg) Normal
cotton
Delicates Acrylic, rayon, (2.5 kg) Low
acetate, etc.
Open the door.
Check the lint filter. If it needs
cleaning then proceed as described
on the right.
Put the laundry in the drum and
close the door.
4
An audible signal will indicate when
the drying program has finished.
The word
Stop will appear on the
display. The display is switched off
three minutes after the end of pro-
gram.
Open the door. Take out the laundry
and check that the drum is empty.
Close the door.
Turn off the power
switch.
FABRICS
Dry fabrics of the same type together to ensure uniform drying.
Symbol means that fabric cannot be tumble dried.
Do not tumble dry...
• fabric labelled “Do not expose
to dry heat”.
• garments that have been dry-
cleaned at home.
P1
P2 P3
P4
Start
Stop
P5
P8 P7
P6
• foam plastic.
• fabric containing glass fibre.
• woollens.
P1
P2
P3 P4
Start
Stop
P5
P8
P7
P6
1
2
Clean the lint filter.
WHEN PROGRAM IS COMPLETE
VENT
ERROR MESSAGES
If an error message appears on the display after completed or
interrupted program, proceed as follows:
- Write down the error message that is displayed.
- Turn off the power switch.
- Open the door and take out
the laundry.
- Contact service.
SAFETY PRECAUTIONS
This machine is not intended for drying dry-cleaned fabrics.
Children must not use this machine.
Do not spray the machine with water when cleaning.
TDC33