Asko TDC33, Service Manual

Page: 52 / 86

50
SERVICE
2
3
THERMISTOR
Removing the thermistor
1. Remove the three screws at the rear edge and
lift off the top cover.
2. Take off the bottom cover (snap fasteners).
3. Remove the protection.
4. Take out the thermistor with the aid of flat-
nose pliers.
NOTE
To check if the thermistor is faulty, a new ther-
mistor can be installed in the fan housing, with
its wire taken outside the machine to the control
board/programmer.
5. Remove the drum in accordance with the sec-
tion "Drum - removing..." .
6. Remove the thermistor from the control board
and the cable from the front frame.
7. Pull out the thermistor's connecting cable.
Installing the thermistor
8. Route the thermistor's connecting cable up
to the control board.
9. Secure the cable in the cable clamps and con-
nect the plug to the control board.
10. Install the thermistor.
NOTE
The rubber seal for the thermistor must provide
a very tight seal
11. Install the drum in accordance with the sec-
tion "Drum - installation..." .
12. Install the protection, bottom and top covers.