ASENWARE Addressable Fire Alarm Control Panel, User Manual

Page: 21 / 66

ASENWARE LTD.
21
Table 2.2 System Fault
FAULT TYPE DESCRIPTION ACTION
Output Fault Loop Card unable to give output Check and correct
LoopCard
Communication Fault
Loop Card missing
Check in programming if registered
and correct
EERON Fault Memory Fault Check and correct or replace
IB Board
Communication Fault Any failure in board Check and correct or replace
2.3.4 Linkage/Supervisory Event
When the panel receives signal from any monitor modules, which is programmed for supervisory
action , following functions are performed by panel :
•
Produce sound at the panel
•
Flashes Yellow Supervisory LED
•
Displays the supervisory information in the Supervisory/Linkage Window , with the type of
description description is programmed for example if Water Flow switch is monitored
using monitor module, when it open and water flows,
display screen show ‘ Water Flow
Switch is open’ (if this message is programmed ).
•
Sends fault message to history buffer, printer and repeater (annunciator panel), if
installed
2.3.4.1 Action to Supervisory Event
Silence the Panel sounder : By pressing the soft key Panel Buzzer Silence , the local sounder
will silence and the Supervisory LED will keep steady. By pressing this, panel will acknowledge
the signal to panel screen, history buffer, printer and annunciator, if installed.
Investigate the condition which causes the supervisory condition. Check if any action is required.
Reset the Panel to normal condition : Once the supervisory condition is investigated and
corrected to normal condition , to return the System to normal condition press RESET soft key on
the panel.