ASEM BM1 Series, User Manual

Page: 27 / 118

21 BM1xx User ’s guide
Warning :
For installation in control cabinets and, in particular, in closed containers, make sure the ambient temperature complies with the requirements.
Attention:
Pour l'installation dans des armoires de commande et, en particulier, dans des conteneurs fermés, assurez-vous que la température ambiante est conforme
aux exigences.
3.1 Preparation for installation
3.1.1 Select the mounting location
The mounting location should comply with the following characteristics:
a) Avoid direct sunlight exposure.
b) Make sure that BM1xx is properly (ergonomically) accessible to the operator.
c) Choose a suitable mounting height.
3.2 Checking the package contents
• Check the package completeness.
• Check if signs of transport damage are visible and, in the case of damaged parts, contact your ASEM representative.
• Do not install parts that were damaged during the shipment.
3.3 Checking the operating conditions
• Read carefully the standards, approvals, EMC parameters and technical specifications for operation of the device. This information
is available in the following sections:
o
Certificates and approvals (refer to section 6.1.2 Certification and approvals ).
o
Electromagnetic compatibility (refer to section 6.1.2 Certification and approvals ).
• Check the mechanical and climatic ambient conditions for operation of the device: Ambient conditions (refer to section 6.1.3
Technical data ).
• Follow the instructions for local use of the device: Notes about usage .
• Adhere to the permissible rated voltage and the associated tolerance range.
3.4 Mounting position
BM1xx device is suitable for wall book mounting / DIN rail installation.
3.4.1 Damage due to overheating
• All BM1xx systems are designed for vertical mounting position.
• The ambient temperature must be between 0°C to +50°C measured 5 cm from all openings of the system where there is air en-
trance.
• Provide space around the system for air recirculation and heat exchange.
•
Mounting angle:
o
The system is intended to be mounted vertically.
o
For other installation modes contact ASEM S.R.L.