TD 92816EN
17-July 2012 / Ver. B
40
Programming and Installation Manual
Care Phone
Precall signal
Determines what type of signal is heard in the loudspeaker on the Analog Care
Phone / GSM Care Phone when a medical alarm is activated. The menu is
multiple-choice <Type 1> <Type 2> <Type 3> <Type 4> and <Not activated>. The
factory default is <Type 1>.
Dial tone detection
Specifies whether the Analog Care Phone / GSM Care Phone shall detect the dial
tone or not, before a telephone number is dialled. If you specify <Activated> the
Care Phone waits until it hears a dialling tone before the number is rolled. If you
specify <Not activated> the Analog Care Phone / GSM Care Phone waits a couple
of seconds before the number is rolled. The factory default is <Activated>. This
setting only applies to the analogue alarm calls.
Mute dialling
Specify if you want to hear the numbers being dialled and the Care Phone's
communication with the alarm receiver in the loudspeaker on the Care Phone or
not. The factory default is <Not activated>.
Polarity change
Specify if the Care Phone shall detect alternation on the telephone line. Factory
default is <Activated>.
9.7
Incoming call
Control of the features used when someone calls to the Care Phone.
>Transmitter Answer< >Ringing signal< >Tele prog signal<
Transmitter Answer
If the transmitter answer is activated, the care recipient can answer an incoming
call by pressing the alarm transmitter. The Care Phone then acts as a standard
speakerphone. By repressing the alarm transmitter the telephone call is
terminated. In Careline GSM you can choose to activate transmitter answer for
the telephone line, the GSM connection or both.
Ringing signal
If the incoming call ringing signal is activated, the Care Phone also rings when
someone calls to a care recipient.
Tele programming signal
Specifies after how many ringing signals Analog Care Phone / GSM Care Phone
shall respond in the remote programming mode when dialling to the care
recipient. The number of signals should normally be 0, which means that the
Care Phone never answers the call.
Possible values are 0 to 255, factory default is 0.
9.8
Timers
Has a submenu, where you can check all alarms that are controlled by a timer.
>Test Alarm< >Link Test< >Away function< >Mains failure< >Mains return <
>Passive Alarm<
