TD 92816EN
17-July 2012 / Ver. B
26
Programming and Installation Manual
Care Phone
5.2.2 Programming the alarm transmitter via the buttons
To program an alarm transmitter for Analog Care Phone / GSM Care Phone
without using the hand terminal, do as follows.
• Press the green button and hold.
• Also press the red and grey buttons and hold them down until an ascending beep is
heard. You can then release all buttons.
• Now you are in the Care Phone programming mode, as indicated by the light switching
between the LEDs.
• Hold down the red, and wait for the number of beeps that corresponds to the
transmitter position you want to program. (See table in section 5.1.3.)
• When the correct number of beeps is heard, release the red button and activate the
transmitter you want to program.
• A received signal is heard from Analog Care Phone / GSM Care Phone when the radio
code has been received.
• To program more transmitters, press the red button again and wait for the beep.
Otherwise, press the green button to exit programming mode.
• Then try to send an alarm from the programmed accessory.
Note:
You can also program as per the previous Care Phones, by turning off the Care
Phone and holding the red button when you restart it and then release the red button and
activate the transmitter in line with the correct number of beeps.
5.2.3 Deprogramming the alarm transmitter via the buttons
• Press the green button and hold.
• Also press the red and grey buttons and hold them down until an ascending beep is
heard. You can then release all buttons.
• Now you are in the Care Phone programming mode, as indicated by the light switching
between the LEDs.
• Hold down the red, and wait for the number of beeps that corresponds to the
transmitter position you want to program. (See table in section 5.1.3.)
• When the correct number of beeps is heard, release the red button and briefly press
the grey button.
• A received signal is heard and the alarm transmitter is then deprogrammed.
• To deprogram more transmitters, press the red button again and wait for the beep.
Otherwise, press the green button to exit programming mode.
Note:
You can also deprogram as per the previous Care Phones, by turning off the Care
Phone and holding the red button when you restart it and then release the red button and
press the grey button in line with the correct number of beeps.
