TD 92816EN
17-July 2012 / Ver. B
18
Programming and Installation Manual
Care Phone
4.2.4 Programming of Protocol
• When sections 4.2.2 and/or 4.2.3 are finished, continue according to the below:
• Press
or
until the protocol is shown in the "new value" field and press Yes to
accept.
• Repeat the procedure for Protocol B, C etc. For each phone number entered in section
4.2.2, a protocol must be specified. The protocol for the addresses are below the
protocols for telephone numbers, but there is the protocol STT IPACS default.
• Press
No
to exit the menu "Protocol".
4.2.5 Programming of Sequences
The programming of sequences defines which alarm types shall call which alarm
receiver and in what order. (See table in Appendix A.) Follow the instructions
below:
• Use
or
to switch between the ten values and positions and
or
to change the
value. The letters represent the listed phone numbers and addresses. If no telephone
number is required for the current position, enter "-".
• When settings are entered, press
Yes
.
• Repeat this procedure for the other sequences that you need.
• Press
No
to return to the "Sequencing" menu
Choose
Protocol
press
Yes
Value
STT
has been
acquired
Choose
Protocol A
press
Yes
Choose
Sequences
press
Yes
Choose
Sequence 1
press
Yes
Choose
Def. sequence
press
Yes
Preset value
Choose new value
